Download 2009 Dodge Viper Ignition Key Removal & Installation – Ignition Key Removal 1. Press the clutch pedal to the floor. 2. Bring the vehicle to a stop. 3. Place the shift lever into gear. 4. Apply the parking brake fully. 5. Press the key removal RELEASE button, turn the key to place the ignition switch in the OFF/LOCK position, and then pull the key out of the switch. NOTE: The Power Accessory Delay feature allows you to operate the radio and the power windows for two minutes after turning OFF the ignition switch. Removing the key from the ignition switch and opening the driver’s door will cancel this feature. Your authorized dealership can enable or disable the Power Accessory Delay feature as desired. Key-In-Ignition Reminder If you open the driver’s door when the key is in the ignition, a chime will sound to remind you to remove the key. NOTE: The Key-In-Ignition reminder only sounds when the ignition switch is placed in the OFF/LOCK or ACC positions. VEHICLE SECURITY ALARM SYSTEM The Vehicle Security Alarm monitors the doors, trunk/liftgate, and hood for unauthorized entry and the ignition switch for unauthorized operation. If something triggers the alarm, the Vehicle Security Alarm will prevent the vehicle from starting. It will also sound the horn and flash the park lights, the taillights and the fog lights. Rearming of the System If something triggers the alarm, and no action is taken to disarm it, the Vehicle Security Alarm will turn off the horn after three minutes, turn off all of the visual signals (flashing lights) after 15 minutes, and then rearm itself.