Download 2005 Scion tC Engine Chain Sub–Assy Replacement Manual – Replacement Notice: When disconnecting the battery negative terminal, initialize the following system(s) after the termi-nal is reconnected. 1. Disconnect battery negative terminal 2. Remove hood sub–assy 3. Remove front wheel rh 4. Remove engine under cover rh 5. Remove engine under cover lh 6. Remove front fender apron seal rh (see page 18–7) 7. Remove engine cover sub–assy no.1 (a) remove the 2 nuts, then remove the engine cover no. 1. 8. Drain engine oil (see page 17–12) 9. Remove exhaust pipe assy front (see page 15–2) 10. Remove fan and generator v belt (see page 14–5) 11. Remove generator assy (see page 19–23) 12. Separate vane pump assy (see page 51–10) 13. Remove engine mounting insulator rh (a) remove the bolt and radiator reserve tank. (b) separate the vane pump oil reservoir from the oil reser-Voir bracket no. 1. Notice: Do not disconnect the 2 hoses. (c) remove the 2 bolts, then separate the return tube. (d) remove the 2 bolts and oil reservoir bracket no. 1. (e) remove the bolt, then separate the wire harness protec-Tor. (f) Disconnect the 2 clamps of the engine wire. (g) place a transmission jack underneath the engine, then Put a wooden block on the jack. (h) remove the bolt and nut, then separate the engine Mounting insulator fr from the engine mounting bracket Fr. (i) Remove the 4 bolts and 2 nuts, then remove the engine Mounting insulator rh. Notice: Do not apply excessive force to the return tube when re-Moving the engine mounting insulator rh.